Installation Manual Software Version 2.1 DLS-1 v6.5 and up.Installer’s Lockout Telephone Lines Any products returned to DSC which have the Installer’s Lockout option enabled and If telephone lines are used to transmit alarms, they may be out of service or busy for certain periods of time.Īlso an intruder may cut the telephone line or defeat its operation by more sophisticated means exhibit no other problems will be subject to a service charge.Table of Contents PC585 Control Panel Wiring Diagram Communicator – Reporting Codes.17 Communicator – Reporting Formats. The entire manual should be carefully read. This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer.

If it says the code was invalid, then the default failed to go through. If the system displays 'Enter Section', then the factory default was successful. The screen will display 'Enter Your Installers Code'. It the default failed, repeat the process and try again.Īn easy way to check if the default went through is to try using the default Installer Code to access programming.

If it has, reconnect the backup battery, and close the panel. Check and confirm that the system has been restored to its factory default settings. This should factory default the system.Ĥ. Then unplug the transformer to power the system back down. Plug in the AC transformer to power the system back on. These inputs are shown in the picture below:ģ. Connect a jumper between inputs IO1 and IO2. Then unplug the AC transformer from the wall outlet. Disconnect the backup battery by unplugging it. Then carefully separate the front of the panel from the back. To do this, use a small screwdriver to press in the two bottom tabs on the front of the panel. Start by opening up the DSC Impassa System. All zones that have been set up with the system will need to be reprogrammed, and all sensors will need to be relearned.Ĭomplete the following steps to perform a factory default on a DSC Impassa Alarm System:ġ. It will also restore the Master Code to 1234 and the Installer Code to 5555. Performing a factory default will restore all system settings to their default. Then disconnect the jumper, and power the system back on. Power up the panel, wait 10 seconds and power down. Then connect a jumper between inputs IO1 and IO2.

You can reset a DSC Impassa to factory defaults by first unplugging the AC transformer and disconnecting the battery to cut power.

Dsc pc585 default master code